Sanyo SPW-C1155DXHN8 Technical Data & Service Manual page 59

2. Wireless Remote Controller
For 1-Way Air Discharge
High-Ceiling Cassette Type (LD Type)
2-7. Installing the Receiver Unit
(1) Push the cover tabs outwards, and pull the cover off to-
ward the front side of the panel. (Fig. 3-11)
(2) Pass the lead wire through the panel, then install the
receiver into the panel hole.
(3) Press the receiver lead wire into the rib along the reverse
side of the panel, and pass the wire through the notch. (Fig.
3-12)
(4) Install the panel onto the indoor unit.
(5) Take the lead wire that extends from the panel and fasten
it to the top surface of the indoor unit using a clamp. (Fig.
3-13)
(6) Use the supplied clamp on the fan casing latch to fasten
the lead wire to the fan casing. Pull the lead wire through
the hole at the bottom of the electrical component box,
and connect the wire to the remote controller terminal
plate. (Fig. 3-14)
NOTE
Do not run the receiver lead wire together with the power
cable or other wiring. Doing so may result in malfunction.
Fasten the lead wire securely so that it does not become
caught in the fan.
If electrical noise occurs in the unit power, a noise filter
must be installed or other suitable measures taken.
* For information on system wiring and conducting a test
run, refer to Section 4 "Electrical Wiring" and Section 7
"Test Run" of the Installation Instructions.
Pull off toward the front side.
Push in
the lead wire.
Panel
Fan casing
Fig. 3-14
3-13
Control of W-2WAY ECO-i SYSTEM
Spread
Spread
Fig. 3-11
Receiver
Rib
Notch
Fig. 3-12 Reverse side of panel
Clamp
Fig. 3-13
Fasten using
the supplied clamp
on the fan casing
latch.
Cover
1
2
3
4
5
6
7
8