How To Wire The Simplified Remote Controller - Sanyo SPW-C1155DXHN8 Technical Data & Service Manual

6. Simplified Remote Controller
1. Insert a screwdriver or the like in the groove on the lower
side of the simplified remote controller body to pry off the
back case. (Fig. 3-57)
2. Use the 2 supplied M4 machine screws to secure the
simplified remote controller back case. Prior to mount-
ing, clear the cutouts in the back case corresponding to
the holes in the wall box using a screwdriver or the like.
Use the spacers and take care not to tighten the screws
excessively. If the back case will not seat well, cut the
spacers to a suitable thickness.
3. Connect locally supplied 3 core lead wires to the lead
wires from the simplified remote controller. (See "How to
wire the simplified remote controller.")
When connecting the locally supplied 3 core lead
wires to the terminal block, check the terminal num-
bers in the indoor unit to make sure that the wires are
correctly connected. (Fig. 3-58)
(The simplified remote controller is damaged if 220 /
240 V AC is applied.)
4. Fit the simplified remote controller to the tabs of the back
case and mount it.
How to Wire the Simplified Remote Controller
Connection diagram
Terminal block
1
for wiring the
remote
2
controller of the
indoor unit
2
* 1: 0.5 mm to 1.6 mm
How to connect lead wires
Lead wire from
2 supplied
indoor unit
white wire
joints
Lead wire
from simplified
remote controller
*1
Connector
Wiring for simplified remote
controller (supplied locally)
2
wires are used for lead wires.
Fig. 3-58
1. Peel off 14 mm of the
cable sheathing.
2. Twist the 2 wires together
and crimp them together
with the wire joint.
3. When a crimping tool is
not used, solder the wires
Wire
together and cover the
joint
joint with insulating tape.
Simplified
WHT
1
remote
controller
2
BLK
Wiring from simplified
remote controller
3-95
Control of W-2WAY ECO-i SYSTEM
Fig. 3-57
1
2
3
4
5
6
7
8