Sanyo SPW-C1155DXHN8 Technical Data & Service Manual page 105

4. System Controller
(a) Zone registration using the remote controller
(RCS-SH80AG)
(Determination of central address)
In this case, after confirming which indoor unit is con-
nected to the remote controller and that the air conditioner
in the OFF state, you set the central addresses one at a
time.
If the system has no remote controller, connect a remote
controller to the system temporarily. Then follow this pro-
cedure.
NOTE
The indoor unit address must already have been set before
performing zone registration. If necessary, refer to the Installa-
tion Manual supplied with the outdoor unit.
(1) Press the and
remote controller for more than 4 seconds.
(2) Do not press button.
(3) Once in this mode, the UNIT No., CODE No., No. of SET
DATA and indications will flash on the display as
shown Fig. 3-41.
NOTE
In case of group control "ALL" instead of "UNIT No." will flash
on the display. Select the main indoor unit address by pressing
the button once.
(4) Set CODE No. to 03 using the
buttons.
NOTE
CODE No. 03 must be selected to perform zone registration
using the remote controller.
(5) Set the Central address which you want to assign to the
indoor unit address using the
buttons according to the zone registration table.
(6) Press the button. The CODE No. and Central address
changes from flashing to ON state. If you make mistake,
then press the button and reset the central address.
(7) Press the button to finish zone registration.
buttons at the same time of the
and
and
Control of W-2WAY ECO-i SYSTEM
For example, in this case
Indoor unit address:1-8
Central address :
3-59
Fig. 3-41
17 (ZONE 2, GROUP 1)
Fig. 3-42
1
2
3
4
5
6
7
8