Makita LS1017L Technical Information page 25

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -8. Up blade guard (cont.)
ASSEMBLING
(1) Set Torsion spring with Location tube inside, and set
Connection shaft and tap it with a plastic hammer.
Torsion spring with Location tube
Fig. 69
(3) Fix Up blade guard with Pin C. And fix Link with
M6x20 H.S.bolt with glue.
Up blade guard
M6x20 H.S.bolt with glue
Fig. 71
(5) Fix Power supply cord with two Cord clamps and
two M4x18 Cross head screws.
Cord clamp
Power supply cord
Fig. 73
Connection shaft
Plastic hammer
Link
Pin C
Cord clamp
M4x18 Cross head screw
(2) Set Up blade guard at the lower dead point and fix
Connection shaft with two M6x12 Lock screws.
Fig. 70
(4) Fix Battery box and Laser cord tube with three
M4x12 Cross head screws.
Be careful that the clearance between the screw
and the rib on Up blade guard is so tight.
Up blade guard
Battery box
Fig. 72
Check that Up blade guard can move to top point with
the reaction force of Torsion spring. If not, tighten the
spring with M6x15 H.S. screw to strengthen the tension
on the spring.
Torsion spring
M6x15 H.S. screw
Fig. 74
P 22/ 45
Up blade guard
Connection shaft
M6x12 Lock screw
Laser cord tube
Rib
M4x12 Cross head screw
Note
Up blade guard
Pin C
Connection shaft