Makita LS1017L Technical Information page 12

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -2. Starter (cont.)
DISASSEMBLING
(2) Unscrew two M5x70 tapping screws and remove Stator by tapping Motor housing with a resin hammer.
Point can be tapped.
ASSEMBLING
(1) Assemble Stator to Motor housing.
Bundle three cables connected
to Soft starter with pieces of tape.
Motor housing
Be careful that two cables from
Starter can be easily pinched out
with Motor housing.
(2) Connect Cables to Soft starter while checking the wiring diagram.
Wrap Cables with pieces of tape
to protect them from being damaged.
Stator
M5x70 tapping screw
Stator
Resin hammer
Fig. 19
First, insert cables connected to
Soft starter, and insert Stator.
Soft starter side
Route Cables connected to
Soft starter to Stator side.
Fig. 20
Fig. 21
P 9/ 45
Motor housing
Right handle
Route Cables from Stator
to the Handle side.
Motor housing
Cables
Soft starter