Digital Audio Dubbing - JVC DR-M10 Instructions Manual

Filename [DR-M10SE_10Editing.fm]
DR-M10SE_01.book Page 84 Thursday, February 12, 2004 9:08 PM
84
EN
Digital Audio
Dubbing
Turn on the TV and select the AV mode.
Slide the TV/CABLE/SAT/DVD switch to DVD.
Optical cable
(not provided)
Player
Rear of unit
Note for connection:
Remove the protection
cap from the cable.
Page 84
You can dub selected audio from a DVD or Audio CD disc to a
digital audio device.
However, it is not possible to dub copy-protected discs.
Example: Dubbing to an MD
A
Connect the unit and a digital audio device using either
an optional optical cable or an optional coaxial cable.
B
For the unit
A Press x to open the disc tray.
Recorder
B Place a disc on the disc tray.
C Press x to close the disc tray.
For the digital audio device
Load an MD.
C
Digital audio
device
A Select the audio to be dubbed.
(MD deck, etc.)
B Start playback slightly before the actual point from
Coaxial cable
C Press 9 to pause playback.
(not provided)
D
DIGITAL OUT
(COAXIAL)
Select the input mode.
E
A Press 4 to start playback on the unit.
B Start recording on the digital audio device.
F
DIGITAL OUT
(OPTICAL)
Stop recording on the digital audio device. Then press 8
to stop playback on the unit.
NOTE:
There may be a discrepancy of several seconds between where
you intend editing to start, and where it actually starts.
Make connections.
Place a disc and load an MD.
Prepare the unit for dubbing.
where you wish to start dubbing.
Prepare the digital audio device for dubbing.
Start dubbing.
Stop dubbing.
Masterpage:Left+
EDITING (cont.)
February 12, 2004 5:23 pm