Adapter Bracket For Indoor Speeddome Housings - American Dynamics SpeedDome Ultra Camera Installation And Service Manual

Adapter Bracket for Indoor
SpeedDome Housings
The following procedure explains how to use an
adapter bracket to mount the dome's base in an
existing indoor SpeedDome
completing this procedure, go to page 2-18 for
dome setup and attachment procedures.
Tool Required
Phillips head screwdriver
Mounting Structure and Install Kit Required
01RHSDA Adapter Bracket*
a) Adapter bracket assembly
* Only part used in this procedure is listed.
SpeedDome Ultra Install Kit 0351-1109-01*
b) Screw, PH, M3x
* Only part used in this procedure is listed.
Procedure
1. Mount the dome assembly's base to the
adapter bracket [a] (Figure Chapter 2-20).
Use two of six screws [b] to attach the base to the
bracket. Tighten screws to secure.
Figure Chapter 2-20. Attaching the mounting
base to the adapter bracket
a
b
housing. After
1 0400-0868-01
6 5801-1051-120
SPEEDDOME ULTRA
2-17
INDOOR INSTALLATION
2. Feed cables as shown, then attach the
adapter bracket to the existing dome
housing (Figure Chapter 2-21).
a.
Seat the ball of the lanyard hanging from the
adapter bracket into the bracket at the top of the
housing.
b.
Squeeze the spring-loaded ejector pins together
to seat the adapter bracket in the corner
receptacles of the housing.
3. Go to "Dome Setup and Attachment", page
2-18.
Figure Chapter 2-21. Attaching the adapter
bracket to the indoor SpeedDome housing
Ejector Pins