American Dynamics SpeedDome Ultra Camera Installation And Service Manual page 26

Wall Mount Structure
This procedure explains how to assemble and
mount the dome's wall mount structure to a wall.
After completing this procedure, go to page 2-18
for dome setup and attachment procedures.
Ensure the wall material, particularly
sheet rock, can support the dome.
Tools Required
Level
Phillips head screwdriver
Drill with 1/4" concrete bit
Ratchet wrench with 5.5mm and 11mm sockets.
Mounting Structure Required
01RHIUWM Wall Mount
a) Bracket, wall mount
b) Cover, wall mount
c) Screw, machine, M3x8, PHP
d) Nut, locking, M3, SS
e) Anchor, Drywall, w/Screw
f) Anchor, Concrete, 1/4-20
g) Washer, Locking, 1/4"
h) Screw, Mach., HXHD, 1/4-20
i) Screw, STAP, 4.8 x 32
Figure Chapter 2-9. Wall mount structure
e
f
1 0500-7664-01
1 0500-7663-01
1 5801-1051-120
2 5826-0200-020
3 2880-0025-02
3 2880-0079-01
3 2847-0101-10
3 2802-8501-54
3 5810-5091-120
g
h
i
SPEEDDOME ULTRA
2-10
INDOOR INSTALLATION
Procedure
Referring to the Figure Chapter 2-9:
1. Place bracket [a] on wall, level, and mark
mounting hole locations.
2. Anchor by performing step a, b, or c.
a.
To sheet rock: Use anchor hardware [e].
b.
To wood: Use locking washer [g] and screw [i].
c.
To concrete: Use anchor [f], locking washer [g],
and screw [h].
3. Attach the base or top hat housing by per-
forming step a or b.
a.
Direct base attachment. Attach the dome's base
to the bracket using two M3 locking nuts [d].
Feed cables as shown.
b.
Top hat housing attachment. See Top Hat
Housing, 8000-1648-01.
4. Place cover [b] over the bracket and secure
using one M3x8 screw [c].
5. Go to "Dome Setup and Attachment", page
2-18.
c
b
a
d
Use side hole for direct
base attachment.
Use center hole for top
hat housing attachment.
Base