Fishfinder Presets - Raymarine e7 User Reference

11.3 Fishfinder presets

The fishfinder provides you with four preset configurations available
from the fishfinder menu. These enable you to quickly select
appropriate settings tailored for various situations.
Each preset has been configured to provide the best operating
parameters for the fishfinder. However, it is possible to manually
adjust the presets if necessary. The four default presets are:
• Single — this preset provides quick access to a single-frequency
configuration, suitable for general fishing conditions.
• Dual — this preset provides a dual frequency configuration.
You can either display two different frequencies at the same
time in one window, or display one frequency at full-screen on
your master display and the other frequency at full-screen on an
additional networked display.
• Shallow — this preset optimizes the fishfinder display for shallow
waters.
• Deep — this preset optimizes the fishfinder display for deep
waters.
Display modes
When using presets, you can either select the relevant preset and
start using the default configuration immediately, or you can adjust
and configure frequencies:
• Zoom
• Bottom Lock
• A-Scope
Any changes you make to a preset are retained when you switch
off the power to your multifunction display.
Selecting a fishfinder preset
From the fishfinder application:
194
1. Select Menu.
2. Select Select Preset.
3. Select the required preset.
The fishfinder display will change to the new mode. This is indicated
in the top left-hand corner of the status bar.
e7 / e7D — User reference