Replacing The Equipment Rack; Replacing Electronic Components; Seat Unit - Invacare Storm 3 Service Manual

Storm³

11.4.1 Replacing the equipment rack

11.4.2 Replacing electronic components

12 Seat unit

The seat unit settings can be individually matched to the user. These settings should therefore
be retained when carrying out service work.
•
Raise lifter (see page 39, chapt. 9.2.2).
•
Remove battery cover (see page 39, chapt. 9.2.1).
•
Squeeze the connector plugs together and pull out of
modules.
•
Unscrew the plastic adjustment screw (1) from the
equipment rack.
•
Unscrew the power module (1), CLAM (2), lighting module
(3), relay (4), strip fuse holder (5), lighting distributor strip
(6) and ACS BUS distributor (7) from the rear side of the
equipment rack (see illustration below).
•
Pull out the Geto Well nuts and check (replace defective
nuts if necessary).
•
Remove equipment rack and replace.
•
Dismantle equipment rack (see above).
•
Pull all connecting plugs out of the modules.
•
Unscrew and replace power module (1), CLAM (2), lighting
module (3), relay (4), strip fuse holder (5), lighting
distributor strip (6) and ACS BUS distributor (7) from the
rear side of the equipment rack.
Reassembly takes place in the reverse order.
Page 54
Service Manual
As at:07.03.02