Storm³
"
Note:
If the old inner tube is to be repaired and re-used, and has become wet during repair,
you can make replacement easier by sprinkling the inner tube with a little talcum
powder.
•
Insert the wheel rim halves from outside into the tyre.
•
Pump up the tyres a little.
•
Insert the Allen screw once again, and screw the wheel rims together tightly.
•
Check that the tyre is seated correctly once again.
•
Pump the tyre up to the prescribed pressure.
•
Check that the tyre is seated correctly once again.
•
Screw the valve cap back on.
•
Refit the wheel.
9.1.4
Replacing the wheel fork
9.1.5
Replacing deep groove ball bearings
•
Remove the front wheel (see page 33, chapt. 9.1.1).
•
Lever the plastic cap off with a screwdriver.
•
Unscrew hexagon cap nut.
•
Remove washer and spring washer.
•
Remove the front wheel with wheel fork downwards.
•
Remove the front wheel (see page 33, chapt. 9.1.1).
•
Lever the plastic cap (1) off with a screwdriver.
•
Unscrew hexagon cap nut (2). When reassembling, secure
the nut using Loctite (e.g. 243).
•
Remove the washer (3).
•
Carefully tap the deep groove ball bearing (4) out.
•
Place the spacer bushes (5) between the bearings and
press in new deep groove ball bearings using a drill guide.
Reassembly takes place in the reverse order.
Page 34
Service Manual
As at:07.03.02