Connecting The Fm And Am (Mw) Antennas - JVC TH-U1 Series Instructions Manual

Connections
Connecting the FM and AM
(MW) antennas
7 AM (MW) loop antenna
Setting up the supplied AM (MW) loop antenna
If the antenna cord is covered with an
insulation coat, twist and pull the
insulation coat off.
Connecting the AM (MW) loop antenna
White
• Turn the loop antenna until you have the best reception
during AM (MW) broadcast program reception.
NOTE
• Make sure the antenna conductors do not touch any other
terminals, connecting cords or power cords. This could cause
poor reception.
• Keep the AM loop antenna cable wrapped around the AM
loop antenna frame, otherwise the effectiveness and
sensitivity of the AM loop antenna may be reduced.
9
Do not connect the power cord until all other connections have been made.
Black
If reception is poor
AM (MW) loop
antenna (white)
Outdoor single vinyl-covered wire
antenna (not supplied)
7 FM antenna
Center unit
If reception is poor
Center unit
Outdoor FM antenna
Standard type (75 Ω
coaxial) connector
(IEC or DIN45325)
We recommend that you use a coaxial cable for the FM
antenna as it is well-shielded against interference.
Center unit
FM antenna (supplied)
Extend the supplied FM antenna
horizontally.
(not supplied)
Outdoor FM antenna cord
(not supplied)