Speed Control Shaft
1. Put the gear cover on the work bench.
2. Using a pliers, remove the inner retainer ring from
the eccentric shaft.
3. Pull the eccentric shaft towards the outer side of the
gear cover so that the fuel pump pin is released.
WARNING
Rotating parts.
Can cause severe injury or death.
Operate the generator set only when
all guards, screens, and covers are in
place.
4. Carefully, using a pliers, unhook the outer torsional
return spring from its boss.
5. Hold the inner control lever and turn down the
accelerator lever until the inner torsional return
spring releases its tension.
6. Release the inner control lever from the eccentric
shaft.
Figure 10-49 Speed Control Shaft
TP-6137 5/03
Governor
1. Install a holding device and remove the governor
pin. See Figure 10-50.
2. Spread the flyweights with a sturdy driver.
3. Use a socket wrench to unscrew the governor.
Note: The governor has a left--hand thread. Unscrew
the governor in a clockwise direction.
Figure 10-50 Governor
Section 10 Generator and Engine Disassembly/Reassembly
71