Circuit Protection; Remote Panel Kits; Remote Start/Stop Panel Kit; Remote Panel Kit - Kohler 4EOZ Service

2.6.5

Circuit Protection

The AC circuit breaker trips when a fault is detected in
the output circuit. After correcting the fault, reset the AC
circuit breaker by placing in the ON position. See
Figure 1-1 for circuit breaker location.
Note: Replace the 25-amp fuse installed in the control
box after a fault. See Figure 1-1 for the fuse
location. Unit is now ready for restart.

2.7 Remote Panel Kits

Remote start/stop panels allow starting or stopping the
generator set from a remote location.
2.7.1

Remote Start/Stop Panel Kit

The remote start/stop panel includes an hourmeter and
start/stop switch. The generator set includes a 4-pin
connector for connection of the remote start/stop panel.
Order a 4- to 6-pin harness kit to connect the panel to the
4-pin connector located at the controller. See Figure 2-4
and Figure 2-5.
1
2
1. Hourmeter
2. Start/Stop switch
3. 6-pin connector
Figure 2-4 Remote Start/Stop Panel Features
1
1. Start/Stop switch connection
Figure 2-5 Remote Start/Stop Panel Connection
8 Section 2 Operation
2.7.2
The remote panel kit includes a start button, an on/off
button, an hourmeter to record total generator set
operating hours, an engine oil pressure light, an engine
water temperature light, and an exhaust gas light. Order
additional extension harnesses for panel connection to
the 25-pin connector.
1. Hourmeter
2. On/Off button
3. Oil pressure lights
4. Engine temperature lights
5. Exhaust temperature lights
6. Start button
Figure 2-6
3
A-226965-A

Remote Panel Kit

1
2
3
4
5
Remote Panel Features
6
GM20768-
TP-6137 5/03