Figure 10-36 T-Handle Tool
Tappets block
1. Release the two push rods by loosening the two
hex cap screws and removing them from the upper
surface of the gear case. See Figure 10-37
Figure 10-37 Gear Case
TP-6137 5/03
Cylinder
1. Rotate the flywheel until the piston reaches the
Bottom Dead Center (BDC) so that the studs are a
guideline to remove the cylinder from the
crankcase. See Figure 10-38.
Note: If the repair does not require replacing the piston
or liner, keep the liner on the piston. Lift up the
liner enough so that the piston pin hole is free.
Continue with the following step.
Figure 10-38 Cylinder
Section 10 Generator and Engine Disassembly/Reassembly
67