Single Bay Usb Cradle; Setup - Motorola MC9500-K Integrator Manual

2 - 22 MC9500-K Series Mobile Computer Integrator Guide

Single Bay USB Cradle

This section describes how to set up a Single Bay USB cradle. For USB communication setup procedures see
Chapter 3, ActiveSync.
The Single Bay USB Cradle:
•
Provides 5.4 VDC power for operating the MC9500-K.
•
Synchronizes information between the MC9500-K and a host computer. See
information on setting up a partnership between the MC9500-K and a host computer.
•
Charges the MC9500-K's battery.

Setup

USB Sync Cable
(USB micro-B to USB A)
Single Bay USB Cradle Power and USB Connections
Figure 2-32
Connect the power supply DC line cord to the power port on the back of the cradle.
1.
Plug the AC line cord into the power supply.
2.
Plug the AC line cord into an AC outlet.
3.
NOTE Ensure that the correct USB Sync cable is used. The cable must have a USB micro-B connector.
Chapter 3, ActiveSync for
AC Line Cord
Power Supply
DC Cable
Power Port
USB Port (micro-AB)