Initial Settings; Plug & Play Set - JVC DR-M100S Instructions Manual

Plug & Play Set
Auto Clock Set/Auto Tuner Set
This unit sets the clock and tuner channels automatically when AC
power cord is first connected to an AC outlet. The antenna cable
must be connected for the Plug & Play setting.
The time and date are set automatically by the clock setting data
transmitted from one of the regular TV broadcast channels. We call
this TV channel the "host channel" and it is a PBS channel in your
area.
ATTENTION:
Depending on areas or reception conditions, the unit may not
receive the Auto clock setting data from the PBS channel. If this
function is taking a considerable amount of time, it may be
necessary to perform the Semiauto or Manual Clock Set
procedure.
STANDBY/ON
INFORMATION
●
If AAUTO CLOCKB is set to AONB (A pg. 19) the clock will be
adjusted automatically by the host channel using the incoming
PBS channel clock setting data. (This automatic clock
adjustment can only be performed when the unit is turned off.)
●
If the memory backup fails, because a power outage occurs or
because the AC power cord is unplugged, Plug & Play will be
performed when power is restored to the unit.
What to do if Plug & Play setting failed
●
If an incorrect time is displayed on the front display panel, you
may be receiving the clock setting data of a PBS channel from
an adjacent time zone, or an incorrect PBS channel from a
cable TV system. In this case, perform "Semiauto Clock Set"
(A pg. 19) or "Manual Clock Set" (A pg. 19).
●
If A- - : - -B appears on the front display panel, your antenna
cable may not be connected to the unit or there may not be a
Host PBS signal available in your area. Ensure that the
antenna cable is connected correctly. Then turn on and off the
unit; the Plug & Play setting will be automatically reactivated. If
Plug & Play setting is not performed though the antenna cable
is connected correctly, perform "Manual Clock Set" (A pg. 19)
and "Auto Channel Set" (A pg. 20) or "Manual Channel Set"
(A pg. 20).
+
CH
RAM/RW
CH-
1
Connect the antenna cable to the unit. (A pg. 16) Then connect
the AC power cord to an AC outlet. Do not turn on the unit. The
clock and tuner channels will be set automatically.
●
ALOADINGB blinks on the front display panel when the AC plug
of the power cord is connected into an AC outlet and it takes
approximately 30 seconds for the unit to be turned on. This is
not a malfunction.
NOTES:
●
Auto Clock Set is performed first. AAUTOB blinks on the front
display panel during Auto Clock Set.
●
Auto Channel Set is performed next. Auto Channel Set scans all
the channels that are receivable by your unit. During Auto
Channel Set, the channel numbers are displayed as they are
scanned and set.
●
When Plug & Play setting has been completed successfully, the
correct clock time is displayed. If you perform Plug & Play setting
successfully, there is no need to perform ACLOCK SETB
(A pg. 19) and ATUNER SETB (A pg. 20). If, however, you want
to add or delete channels, refer to AMANUAL CH SETB
(A pg. 20).
During Auto Clock Set
AAUTOB blinks.
PUSH-OPEN
During Auto Channel Set
The channel numbers are displayed and AAUTOB blinks as
they are scanned and set.
Plug & Play Completed
The current time is displayed.
●
If an incorrect clock time or A- - : - -B appears on the front
display panel, see "What to do if Plug & Play setting
failed" on the left column.

INITIAL SETTINGS

17
EN