Remote Control/System Connections; Remote Control Functions; Connecting To A Dolby Digital Decoder Or An Amplifier With Built-In Dts - JVC DR-M100S Instructions Manual

Remote Control Functions

Remote Control 1/2/3/4 Code Switching
The remote control is capable of controlling four JVC video units
independently. Each of the units can respond to one of the four
codes (1, 2, 3 or 4). The remote control is preset to send code 3
signals because your unit is initially set to respond to code 3
signals. You can easily modify your unit to respond to code 1, 2 or
4 signals.
A
1-4
●
Keep pressing SET UP down during step 1.
1
Press the number key "1" for 1, "2" for 2, "3" for 3 or "4" for 4 to
change the remote control code, then press ENTER.
2
Press A on the unit to turn off the unit.
3
Press I on the unit for over 5 seconds while the unit is turned
off. The code currently set appears on the front display panel.
4
Press o on the remote control to change the unit's code. The
code currently set on the remote control blinks on the front
display panel for approximately 5 seconds, and is applied to the
unit.
RAM/RW
I
ENTER
o
SET UP

REMOTE CONTROL/SYSTEM CONNECTIONS

Connecting To A Dolby Digital Decoder
Or An Amplifier With Built-in DTS
These instructions enable you to connect your unit to a Dolby
Digital Decoder or an amplifier with built-in DTS.
Dolby Digital Decoder or
amplifier with built-in DTS
To [DIGITAL OUT
1
Connect the unit and a Dolby Digital Decoder or an amplifier
with built-in DTS using an optional coaxial cable.
NOTE:
For details on [DIGITAL OUT] connector setting, refer to "DIGITAL
AUDIO OUT". (A pg. 58)
To DIGITAL AUDIO
input
Coaxial cable
(not supplied)
(COAXIAL)]
Rear of unit
57
EN