Setting System Passwords - Motorola BSR 64000 Quick Start Manual

RDN>enable
The Password prompt displays.
7. To enter Privileged EXEC mode, press the Enter key at the password prompt. The
password is a null value by default.
8. To enter Global Configuration mode in order to set system passwords, use the
configure command, as shown in the following example:
RDN#configure
The RDN(config)# prompt displays.

Setting System Passwords

System passwords should be set immediately. System passwords can contain up to 31
uppercase or lowercase alphanumeric characters and a numeric character cannot be
the first character. Spaces are valid password characters. The user must enter the
correct password to gain access to the BSR and privileged-level commands.
Note: Access to a telnet session is denied if the password for both the
console and telnet is not set.
Follow these steps to configure the BSR system passwords:
1. To set the password for a console (terminal) session that allows access to the BSR
in User EXEC mode, use the password console command in Global
Configuration mode, as shown below:
RDN(config)# password console {0 | 7} <password>
where:
0 indicates that the following password is unencrypted (clear text).
7 indicates that the following password is encrypted.
password is the user-defined password that is no more than 31 characters.
Quick Start
5