4. The upstream ports are in a shut-down state by default. To enable the upstream
ports, use the no cable upstream shutdown command in Interface Configuration
mode, as shown in the following example:
RDN(config-if)#no cable upstream shutdown
Refer to the following documents for additional instructions:
•
BSR 64000 Configuration and Management Guide
•
BSR 64000 Command Reference Guide
Save the Configuration
Follow these steps to save the current running configuration:
1. To copy the current system configuration to the system startup configuration, use
the copy running-config startup-config command in Privileged EXEC mode, as
shown in the following example:
RDN#copy running-config startup-config
2. Reboot the BSR.
3. To verify that changes were implemented, use the show running-config
command in Privileged EXEC mode as shown in the following example:
RDN#show running-config
Refer to the following documents for additional instructions:
•
BSR 64000 Configuration and Management Guide
•
BSR 64000 Command Reference Guide
Quick Start
19