Port Leds; 10/100/1000Base-T Rj-45 Ports; Gigabit Sfp Slots; Mode Button - Motorola EX-3524 Installation Manual

10 EX-3524/EX-3548 Layer 2 Gigabit Ethernet PoE/PoE+ Switch

2.5.1 Port LEDs

For information on port status LED indicators, see Port Status LEDs on page 13.

2.5.2 10/100/1000BASE-T RJ-45 Ports

The switch contains 24 10/100/1000BASE-T RJ-45 ports that support 10/100/1000BASE-T copper links to other
devices. For more information, see Connecting Twisted-Pair Cables on page 20.

2.5.3 Gigabit SFP Slots

The switch contains four Small Form Factor Pluggable (SFP) transceiver slots that operate up to Gigabit full duplex.
For more information, see Connecting to SFP Ports on page 22.

2.5.4 Mode Button

Pressing the Mode button on the front panel will change the Diag LED to display PoE status. For more information,
see LED Codes on page 12.

2.5.5 Console Port

The RJ-45 connector on the front panel far right side that is labeled "Console" provides an out-of-band serial
connection to a terminal or a PC running terminal emulation software. The port can be used for performing switch
monitoring and configuration. For more information, see Connecting to the Console Port on page 24.

2.5.6 System LEDs

For information on system status LED indicators, see LED Codes on page 12.

2.5.7 Reset Button

Pressing the reset button on the rear panel causes the switch to execute a hard reset. For more information, see
Resetting the Switch on page 26.

2.5.8 Ground Point

The switch should be connected to ground using this screw connection. For more information on how to connect
ground to the switch, see Power and Grounding on page 18.