Table of Contents
Advertisement
INSTALLATION OF CAR ANCHOR FITTING
Extension Strap distance to be measured.
Length 300mm (Use Safe-n-Sound part 0035 or equivalent).
Length 600mm (Use Safe-n-Sound part 0036 or equivalent).
Available from all major child restraint retailers.
Adjustable upper
Anchorage strap.
The shaded areas of this diagram illustrate the possible locations of the anchor
fitting. Within each shaded area is an anchor fitting showing the correct way to install
the fitting. Ensure the anchor fitting is aligned as illustrated unless stated otherwise in
the vehicle owner's handbook.
52
DISTANCE TO MEASURE TO
THE ANCHOR POINT
FRONT OF VEHICLE
INSTALLATION OF CAR ANCHOR FITTING
IF THE CAR IS FITTED WITH CHILD
RESTRAINT ANCHORAGE POINT
Locate the anchorage point behind the rear
seating position. (consult the car owners
handbook for the location of the anchorage
point). The anchorage point should be
directly behind and central to the restraint.
Remove thread plug from the parcel shelf/
floor/roof, etc. and install anchor bolt and
fitting as shown in Fig 1.
CAUTION: DO NOT OVERTIGHTEN ANCHOR
BOLT. OVERTIGHTENING MAY FRACTURE OR
BREAK BOLT. MAXIMUM TORQUE IS 20 Nm
(14.75 ft.lb.)
Note: Minimum of five full turns of anchor
bolt is required before tightening force is
applied.
UPPER ANCHORAGE FITTING
Fig.1.
Attachment Bolt
Lock washer
Anchor fitting
Spacer(s) if
required
Vehicle trim
Vehicle metal
structure
Front of Vehicle
53
Advertisement
Table of Contents
