Table of Contents
Advertisement
TRAVEL SYSTEM - BRITAX ADAPTORS
C. Then place Press Pin in bottom hole and
push into place.
D. To replace trim pull elastic underneath the adaptor and hook. Place elastic in
groove shown below.
48
C
Push in Press Pin
Hook elastic
behind the
adaptor and
place in
groove
TRAVEL SYSTEM - BRITAX ADAPTORS
TO INSTALL INFANT CARRIER INTO STROLLER -
BRITAX STROLLER ADAPTOR METHOD
IMPORTANT :
Only use Infant Carrier with compatible
Britax/Steelcraft Stroller.
A. Where applicable, remove the stroller seat or
bassinet from the stroller frame (refer to stroller
instructions). With the Infant Carrier handle in the
carry position, engage the Infant Carrier Adaptor on
each side directly over the stroller frame mouldings.
B. Push down on the Infant Carrier and make sure it is
located into the stroller frame mouldings. The Carrier
is not yet fixed to the stroller.
C. Rotate Handle into rocking position to lock the
Carrier into stroller.
VERY IMPORTANT:
Always lock the Infant Carrier to the stroller frame
by rotating the handle.
IMPORTANT:
Pull up Carrier to ensure it is locked in position.
D. If the baby is not already in the Infant Carrier then secure your baby into the Infant
Carrier by the harness (see page 25)
A
B
Lock
C
49
Advertisement
Table of Contents
