Table of Contents
Advertisement
HOW TO USE
C. Ensure slack is removed from the lap straps
by pulling the shoulder harness straps through
the buckle tongues, then pull the Harness
Adjustment Strap to take up the slack in the
harness, adjusting to a firm but
comfortable fit. Make sure that
the baby's arms and legs are
free and the crotch strap is
between the legs. Check that
the slack in straps is minimal.
Do not use the restraint if
straps do not tighten and
contact your local authorised
service agent for repair.
Hook the Adjuster Strap on to the loop
to prevent tripping over the strap.
CAUTION: A LOOSE HARNESS IS DANGEROUS
Ensure the end of the harness Adjustment Strap is connected to the cover
to avoid tripping on the end. Ensure the Harness adjustment strap hook is
attached when carrying the carrier (see above).
28
Pull Harness Straps
through the buckle in
direction of arrows
Pull Harness Adjustment
Strap to remove slack.
PLACING BABY & INFANT CARRIER IN BASE
A. Position the Infant Carrier over the top of the
base. Make sure the Harness Adjustment Strap is
not caught between Infant Carrier and Base then
lower the Infant Carrier into position.
B. Push down on the Infant Carrier until an
audible click is heard. Pull on the Infant Carrier
to ensure it is correctly locked into position.
IMPORTANT:
Lift again to check engagement.
C. The handle may be rotated into other positions if
needed although this may be difficult with the seat
in front.
HOW TO USE
Click
29
Advertisement
Table of Contents
