Table of Contents
Advertisement
HOW TO INSTALL
INSTALLING UPPER ANCHORAGE STRAP
A. Locate the child restraint anchor fitting
in the car that is directly behind the
seat location in the rear seat you have
chosen. Refer to the car owner's
manual for the location (If there is no
anchorage fitting then refer to pages
51 - 55 for instructions in adding
an anchor fitting). Connect the Upper
Anchorage Strap Attachment Clip to the
Anchor Fitting.
Lengthen the strap by pressing the
adjuster button (1) and pull the strap (2)
so that the strap is ready to attach to the
Carrier.
THIS UPPER ANCHORAGE STRAP MUST
ALWAYS BE FITTED WHEN THE INFANT
CARRIER IS USED IN THE CAR.
B. While the Infant Carrier is out of the car, store the upper anchorage strap between
the stabilising bar and the car seat back so that it will be ready for use when the
Infant Carrier is put back in the car.
Always attach hook and remove slack.
24
Attachment Clip
Car's Anchor Fitting
Fully press Adjuster Button (1) while
pulling Upper Anchorage Strap (2) to
lengthen.
1
2
PLACING BABY IN INFANT CARRIER
When positioning baby into Infant Carrier make sure baby's back is fully supported
onto the flat section and the baby's nappy area (bottom) is resting in the bottom
curvature as shown. It is recommended that bulky nappies are not used when baby
is travelling in the Infant Carrier as they can cause incorrect positioning of the baby's
back in the Infant Carrier.
A. Loosen Harness Straps by pressing the Harness
Adjuster while grasping both the Shoulder Harness
Straps and pulling out the desired amount of slack.
Press the Harness
Adjuster and pull Harness
Straps to loosen.
HOW TO USE
Flat section of
Infant Carrier
Bottom curvature of
Infant Carrier
25
Advertisement
Table of Contents
