Table of Contents
Advertisement
HOW TO USE
D. Ensure the upper anchorage strap attachment clip
have been fitted to the car's anchor fitting. If not
already connected, refer to page 24.
E. Feed the Upper Infant Carrier strap on the inside
of the handle and through the locating slots in
the front of the Infant Carrier.
F. Adjust the Upper Anchorage Strap by pulling as
shown below to remove any slack in the straps.
Do not over tighten.
Pull to
remove slack
Press button to
lengthen
Adjuster
IMPORTANT :
The Upper anchorage strap must be fitted at all times when the baby is in the car.
30
Locating Slots
Upper anchorage strap
Upper Anchorage Strap.
REMOVING BABY & INFANT CARRIER FROM BASE
A. Loosen the upper anchorage strap. Ensure that the adjuster does not fall on the
baby.
B. Remove the upper anchorage strap from the locating slots in the Infant Carrier.
C. Store the anchorage strap between the rebound bar and the car seat back so
that it will not fall behind the seat or get trapped in
the door. This will keep the upper anchorage strap
visible and ready for use when the Infant Carrier is
put back in the car.
D. Rotate the Carry Handle to the "carry" location
(page 13).
E. Grasp the handle with one hand lifting the Infant
Carrier release catch with the other hand. With the
catch lifted raise the Infant Carrier clear of the base.
Always ensure the handle is locked in position
before lifting.
F. When the Infant Carrier is clear of the base, carefully
remove it from the car.
Ensure the Adjustment Strap hook is connected to the
cover, See page 28.
HOW TO USE
Lift
Pull Catch
31
Advertisement
Table of Contents
