Table of Contents
Advertisement
HOW TO INSTALL
C. Place the base into the car in the selected
seating position with the Stabilising bar
beside the car's seat back as shown.
D. Extend the seat belt to maximum length.
For a lap-sash seat belt, position the
tongue in the middle of the fully extended
belt. Feed the seat belt through the blue
REAR-FACING SEATBELT PATH labels on
each side through the Belt Guide Hooks.
Blue REARWARD-FACING
22
BELT PATH label
Belt Guide
Hooks
D. Engage the seat belt tongue to
the buckle.
E. Pull the slack out of the seat
belt and ensure the base is held
firm against the seat back. If a
lap-sash seat belt is used then
allow the excess sash belt to
feed back in to the retractor.
To remove the base from the car, release the seat
belt, pull the seat belt out.
NOTE: Seat belt extenders should not be used if the seat
belt is not long enough to secure the child restraint. If
they are used then the buckle must not contact the Belt
Guide Hooks.
If the seat belt will not stay tight in every day use, then fit a 3-bar gated buckle to the
lap-sash belt to prevent loosening. See pages 56 to 57. (Not supplied with seat).
HOW TO INSTALL
Belt Guide Hooks
Pull Sash portion
of seatbelt to
remove slack
23
Advertisement
Table of Contents
