Oximax Sensor Attached - Nellcor Oximax NPB-40 Operator's Manual

NPB-40 Operation
O M Sensor Attached
XI
AX
When a sensor contains data and is attached to the
NPB-40, the Data In-Sensor indicator is shown.
The NPB-40 displays two dashes in the %SpO
Rate displays as the NPB-40 searches for a valid pulse.
For optimal performance, allow the NPB-40 to search
and lock onto a pulse for approximately 10 seconds in
non-motion conditions.
When a valid pulse is detected, the NPB-40 enters the
normal mode and displays patient parameters.
Movement of the blip bar indicates that real-time data is
being displayed. Listen for the pulse beep tone. If the
pulse beep tone does not sound with each pulse, it is an
indication that the pulse beep volume is set to zero, the
speaker has malfunctioned, or the signal is corrupted.
42
and Pulse
2