Preparations - Panasonic WV-SF138 Installation Manual

Preparations

You can install the camera on a ceiling or a wall. (
IMPORTANT:
• Procure 3 screws (M4) to secure the camera to a ceiling or a wall, according to the material of
the installation area. In this case, wood screws and nails should not be used. For mounting a
camera on a concrete ceiling, use an anchor bolt (for M4) or an AY plug bolt (M4) for securing.
(Recommended tightening torque: 1.6 N·m {1.18 lbf·ft})
• Required pull-out capacity of a single screw/bolt is 196 N {44 lbf} or more.
• If a ceiling board such as plaster board is too weak to support the total weight, the area shall
be sufficiently reinforced.
The mounting conditions of the camera are described as follows:
Installation
place
Ceiling/wall
Using the side cable access hole
When installing the camera directly on the ceiling or wall with cables exposed, cut out a portion of
the enclosure to open a cable access hole.
Side cable access hole
16
(Direct mounting)
Pages 16 and 17)
Recommended Number of
screw screw
M4 3 pcs.
Minimum pull-out
strength (per 1 pc.)
196 N {44 lbf}
Side cable access hole