Panasonic WV-SF138 Installation Manual page 11

card will be deleted when formatted. If an unfor-
matted SD memory card or an SD memory
card formatted with other devices is used, this
product may not work properly or performance
deterioration may be caused. Refer to the
Operating Instructions (included in the CD-ROM)
for how to format a SD memory card.
• When some SD memory cards are used
with this product, the product may not
work properly or performance deterioration
may be caused. Use the SD memory cards
recommended in page 30.
About the microphone
• Volume may be reduced if any water adheres
to the microphone opening. Please allow it to
sit and dry thoroughly prior to using again.
• When cleaning, please do not poke the micro-
phone opening with any sharp object. This
may cause it to become wet or damaged.
Code label
The code labels (accessory) are required at
inquiry for trouble. Use caution not to lose
these labels. It is recommended to paste one
of the labels onto the CD-ROM case.
About the MOS image sensor
• When continuously shooting a bright light
source such as a spotlight, the color filter of
the MOS image sensor may have deteriorat-
ed and it may cause discoloration. Even
when changing the fixed shooting direction
after continuously shooting a spotlight for a
certain period, the discoloration may remain.
• When shooting fast-moving subjects or perform-
ing panning/tilting operations, objects crossing
the shooting area may look to be bending askew.
AVC Patent Portfolio License
THIS PRODUCT IS LICENSED UNDER THE AVC
PATENT PORTFOLIO LICENSE FOR THE
PERSONAL USE OF A CONSUMER OR OTHER
USES IN WHICH IT DOES NOT RECEIVE
REMUNERATION TO (I) ENCODE VIDEO IN
COMPLIANCE WITH THE AVC STANDARD ("AVC
VIDEO") AND/OR (II) DECODE AVC VIDEO THAT
WAS ENCODED BY A CONSUMER ENGAGED
IN A PERSONAL ACTIVITY AND/OR WAS
OBTAINED FROM A VIDEO PROVIDER LICENSED
TO PROVIDE AVC VIDEO. NO LICENSE IS
GRANTED OR SHALL BE IMPLIED FOR ANY
OTHER USE. ADDITIONAL INFORMATION MAY
BE OBTAINED FROM MPEG LA, L.L.C.
SEE HTTP://WWW.MPEGLA.COM
Flickering
Due to the influence of lighting, flickering may
sometimes happen. In this case, select "Indoor
scene" for "Light control mode". Select "Indoor
scene(50Hz)" or "Indoor scene(60Hz)" in accor-
dance with the power supply frequency in your
locality. Refer to the Operating Instructions
(included in the CD-ROM) for further informa-
tion about the setting.
Under extremely strong lighting, flickering may
happen even when "Indoor scene" is selected
for "Light control mode".
When the brightness (illuminance) level on the
screen is set to a relatively low level with the
[Brightness] buttons, flickering may frequently
happen. In such cases, either of the following
can reduce flickering.
• Moderate the illumination intensities of
objects by changing the camera direction.
• Set the brightness (illuminance) level on the
screen to a brighter level with the
[Brightness] buttons.
White-out on images caused by the effect
of light control mode
When "Indoor scene" is selected for "Light
control mode", the tone of the brighter parts on
the screen may be deteriorated than the case
when "ELC" is selected.
Color blurring on detailed drawing patterns
When there are detailed drawing patterns on
images, color blurring may happen over these
parts.
Operating temperature
This product can be used in low temperature
outdoor environments that get as cold as
–30 °C {-22 °F}. However, when this product is
installed and operated in temperatures below
–20 °C {-4 °F}, normal images may not be
obtained immediately after startup. In such a
case, connect the power and wait approx.
2 hours, and then connect the power again.
Brightness around the images
The surrounding area of the image may appear
slightly dark depending on the shooting subject.
11