Ford Expedition 2000 Workshop Manual page 9

2000 Expedition/Navigator Workshop Manual
25. Position the lower end of the RH (outer) timing chain on the crankshaft sprocket, aligning the timing mark on the sprocket with the single copper (marked) chain
link.
26. NOTE: The lower half of the timing chain must be positioned above the tensioner arm dowel.
NOTE: If necessary, use the Camshaft Alignment Set to adjust the camshaft sprocket slightly to obtain timing mark alignment.
Position the RH timing chain on the camshaft sprocket. Make sure the camshaft sprocket timing mark is positioned between the two copper (marked) chain links.
27. Position the RH timing chain tensioner arm on the dowel pin and install the RH timing chain tensioner.
28. Remove the retaining clip from the RH timing chain tensioner.
29. As a post-check, verify correct alignment of all timing marks.
http://www.fordtechservice.dealerconnection.com/pubs/content/~WSYJ/~MUS~LEN/21/S...
Page 9 of 20
1/19/2011