Ford Expedition 2000 Workshop Manual page 13
Cylinder heads — 5.4l
Hide thumbs
Also See for Expedition 2000:
- Owner's manual (256 pages) ,
- Operator's handbook manual (60 pages) ,
- Operation manual (60 pages)
Advertisement
2000 Expedition/Navigator Workshop Manual
40. Lubricate the engine front cover and the front oil seal inner lip with clean engine oil.
41. Use the special tools to install the crankshaft front oil seal into the engine front cover.
42. NOTE: If not secured within four minutes, the sealant must be removed and the sealing area cleaned. To clean the sealing area, use silicone gasket remover and
metal surface prep. Follow the directions on the packaging. Failure to follow this procedure can cause future oil leakage.
Apply silicone gasket and sealant to the Woodruff key slot on the crankshaft pulley.
43. Use the special tool to install the crankshaft pulley.
44. NOTE: Use a suitable strap wrench (303-D055) to hold the pulley while tightening the bolt.
http://www.fordtechservice.dealerconnection.com/pubs/content/~WSYJ/~MUS~LEN/21/S...
Page 13 of 20
1/19/2011
Advertisement
