2000 Expedition/Navigator Workshop Manual
LH cylinder head
3. NOTE: Make sure to tighten the bolts in sequence in three stages.
Tighten the LH bolts in the sequence shown.
Stage 1: Tighten to 40 Nm (30 lb-ft).
Stage 2: Tighten an additional 90 degrees.
Stage 3: Tighten an additional 90 degrees.
RH cylinder head
4. NOTE: Make sure to tighten the bolts in the following three stages.
Tighten the RH bolts in the sequence shown.
Stage 1: Tighten to 40 Nm (30 lb-ft).
Stage 2: Tighten an additional 90 degrees.
Stage 3: Tighten an additional 90 degrees.
http://www.fordtechservice.dealerconnection.com/pubs/content/~WSYJ/~MUS~LEN/21/S...
Page 3 of 20
1/19/2011