Table of Contents
Advertisement
SEPIA: Recorded scenes have a brownish tint
like old photos. Combine this with the Cinema
mode for a classic look.
STROBE: Your recording looks like a series of
consecutive snapshots.
1) To start playback, press PLAY (U).
2) Press EFFECT. The PLAYBACK EFFECT Select
Menu appears.
3) Press EFFECT repeatedly to move the highlight
bar to the desired effect.
The selected function is activated and after
2 seconds the menu disappears.
To deactivate the selected effect, press EFFECT
ON/OFF. To reactivate the selected effect press
EFFECT ON/OFF again.
To change the selected effect, repeat from
step 2 above.
Audio Dubbing
The audio track can be customised only when
recorded in the 12-bit and SP modes. (
Speaker
A.DUB
PLAY
PAUSE
STOP
RM-V717U (optional)
1
Play back the tape to locate the point where
editing will start, then press PAUSE (9).
2
While holding A. DUB (D) on the remote
control, press PAUSE (9). The "9D" and "MIC"
indicators appear.
3
Press PLAY (U), then begin "narrating". Speak
into the microphone.
To pause dubbing, press PAUSE (9).
4
To end Audio Dubbing, press PAUSE (9), then
STOP (8).
pg. 34)
Stereo Microphone
PAUSE
PLAY
A.DUB
STOP
T
W
RM-V718U (provided)
To hear the dubbed sound during playback...
Set "12bit MODE" to "SOUND 2" or "MIX".
(
pg. 31, 40)
NOTES:
Sound is not heard from the speaker during Audio
Dubbing.
When editing onto a tape that was recorded at
12-bit, the old and new soundtracks are recorded
separately.
If you dub onto a blank space on the tape, the
sound may be disrupted. Make sure you only edit
recorded areas.
If feedback or howling occurs during TV playback,
move the camcorder's microphone away from the
TV, or turn down the TV's volume.
If you change from 12-bit to 16-bit in mid-
recording and then use the tape for Audio
Dubbing, it is not effective from the point where
16-bit recording began.
During Audio Dubbing, when the tape moves to
scenes recorded in the LP mode, scenes recorded
in 16-bit audio or a blank portion, Audio Dubbing
stops.
To perform Audio Dubbing while watching on the
television, make connections. (
To perform Audio Dubbing with a video unit
connected to the camcorder's S/AV connector, first
set "S/AV INPUT" to "A/V. IN" or "S. IN" in VIDEO
Menu. (
pg. 31, 40)
The "AUX" indication appears instead of "MIC".
#' #' #' #'
EN
EN
EN
EN
pg. 22)
Advertisement
Table of Contents
