Table of Contents
Advertisement
Automatic Demonstration
Automatic Demonstration takes place when "DEMO
MODE" is set to "ON" (factory-preset).
Lock Button
SELECT/SET
Button
+/- Button
MENU Button
SY
ST M
DE O
M
MO
DE
Power Switch
Sub Menu
E
–
OFF
O
N
Automatic Demonstration starts when there is no
operation for about 3 minutes after the Power
Switch is set to "A" or "M" and no cassette is in
the camcorder.
Performing any operation during the
demonstration stops the demonstration
temporarily. If no operation is performed for more
than 3 minute after that, the demonstration will
resume.
"DEMO MODE" remains "ON" even if the
camcorder power is turned off.
To cancel Automatic Demonstration
1
Set the Power Switch to "M" while pressing down
the Lock Button located on the switch.
2
Open the LCD monitor fully, or pull out the
viewfinder fully.
3
Press MENU. The Menu Screen appears.
4
Press + or – to select "s", and press SELECT/
SET. The SYSTEM Menu appears.
5
Press + or – to select "DEMO MODE", and press
SELECT/SET. The Sub Menu appears.
6
Press + or – to select "OFF", and press SELECT/
SET.
7
Press + or – to select "BRETURN", and press
SELECT/SET twice. The normal screen appears.
NOTE:
Detach the lens cap to see the actual changes of the
Automatic Demonstration activated on the LCD
monitor or viewfinder.
' ' ' '
EN
EN
EN
EN
Advertisement
Table of Contents
