Table of Contents
Advertisement
Indications
INSERT ERROR!
<CANNOT EDIT ON A
LP RECORDED TAPE>
<CHECK TAPE'S
ERASE PROTECTION
TAB>
MEMORY IS FULL
COPYING FAILED
MEMORY CARD!
PLEASE FORMAT
NO IMAGES STORED
NO E-MAIL CLIP
STORED
CARD ERROR!
UNSUPPORTED FILE!
CHECK CARD'S WRITE
PROTECTION SWITCH
E01, E02 or E06
UNIT IN SAFEGUARD
MODE REMOVE AND
REATTACH BATTERY
E03 or E04
UNIT IN SAFEGUARD
MODE EJECT AND
REINSERT TAPE
Appears if Insert Editing is attempted on a tape recorded in the LP mode.
Appears if INSERT (I) on the remote control is pressed when the erase
protection tab is set to "SAVE".
Appears when the memory card's memory is full and shooting is not possible.
Appears if dubbing of copyguarded signals is attempted while this camcorder
is being used as a recorder.
Appears in the following cases when dubbing from a tape to a memory card (as
digital stills or video clips):
– when no memory card is loaded.
– when the memory card's memory is full.
– when the memory card is not formatted.
– when a write-protected SD Memory Card is loaded.
Appears if there is no memory card loaded when you attempt to record on a
memory card or access data on a memory card.
Appears when there is a problem with a memory card and its memory is corrupt,
or it has not been initialized. Initialize the memory card.
Appears if there are no image files stored in the memory card when you attempt
memory card playback.
Appears if there are no video clip files stored in the memory card when you
attempt memory card playback.
Appears when the camcorder does not recognise the loaded memory card.
Remove the memory card once and insert it again. Repeat these procedures until
no indication appears. If the indication still appears, the memory card is
corrupted.
Appears when playing back a file that is not compatible with DCF or a file with a
size that is not compatible with this camcorder.
Appears when you attempt to shoot digital still images when the write
protection tab on the SD Memory Card is set to the "LOCK" position.
Appears when you attempt MEMORY SELECT menu operation with a write-
protected SD Memory Card loaded.
The error indications (E01, E02 or E06) show what type of malfunction has
occured. When an error indication appears, the camcorder turns off
automatically. Remove the power supply (battery, etc.) and wait a few minutes
for the indication to clear. When it does, you can resume using the camcorder. If
the indication remains, consult your nearest JVC dealer.
The error indications (E03 or E04) show what type of malfunction has occured.
When an error indication appears, the camcorder turns off automatically. Eject
the cassette once and re-insert it, then check if the indication clears. When it
does, you can resume using the camcorder. If the indication remains, consult
your nearest JVC dealer.
Function
&# &# &# &#
EN
EN
EN
EN
(
pg. 60)
(
pg. 60)
(
pg. 51, 55)
(
pg. 30)
Advertisement
Table of Contents
