First Alert FA142C Installation Instructions Manual page 76

Press 94 DOWNLOAD PHONE NUMBER
Enter up to 12 digits;
0–9, # + 11 for " ", # + 12 for "#", # + 13 for a pause. Do not fill
unused spaces. End field by entering " ". To clear entries, press
94 .
Press 95 RING DETECTION COUNT FOR DOWNLOADING
Refer to the chart below and program this field accordingly.
Voice Answering
Module Machine
Yes No
Yes Yes
Yes No
Yes Yes
No No
No Yes
No No
No Yes
Important Note: If "15" is entered in field
machine, and a 4285 Phone Module is included in the installation, you
should note the following:
When calling in from an off-premises phone (to receive a status report or
execute a command), the user should make the initial call, allow 1 to 3 rings
only, and hang up. Then call in again – the Phone Module will now seize
the line, and 2 long tones will be heard, followed by the usual voice prompt
for the 2-digit phone access code. If this procedure is not followed, Phone
Module operation will not be possible.
96 INITIALIZE DOWNLOAD ID AND SUBSCRIBER ACCT. No. FOR
DOWNLOADING (No data entry required)
This completes the communication programming.
Exit the programming mode by keying 99.
Refer to the TESTING THE SYSTEM section to check system operation.
– 76 –
Downloading Field 95 Programming
No Set for value other than "0" (1–14).
This will enable the control panel to
answer the phone call. Otherwise, it
will not be possible to access the
Module.
No Set for a value higher than the
number of rings for which the
answering machine is set. Example:
if machine is set for 4 rings, use a
value of 5 or higher. This is recom-
mended so that the Phone module
can still be accessed if the answering
machine is turned off and does not
answer the phone call.
Yes Set for value other than "0" (1–14).
Yes "15" to bypass answering machine.
No Enter "0"
No Enter "0"
Yes Enter 1–14
Yes Enter 15. See Imortant Note below.
95 to bypass an answering