First Alert FA142C Installation Instructions Manual page 75

Press 62 AC LOSS REPORT CODE
Reports with Subscriber No. Timing of this report is random with
up to a 48-minute delay. The Restore report has a random delay
of up to about 12 minutes. If AC restores before the report goes
out, there is no AC restore report.
Press 63 LOW BAT REPORT CODE
This will be sent when a low battery condition exists in the
system's standby battery.
Note: Connection to the standby battery is checked every 3
minutes (CSFM requirement).
Press 64 TEST REPORT CODE
This is sent periodically to test that the communicator and phone
lines are operational (frequency of report is selected in field 51).
Press 65 OPEN/EXIT ALARM REPORT CODE
This is sent upon disarming of the system. 2nd digit = User No., if
expanded or 4+2 reporting is selected.
Press 66 ARM AWAY/STAY REPORT CODES
This option allows for independent programming of AWAY and
STAY reports . 2nd digit of Report is User No., if expanded or 4+2
reporting is selected.
Press 67 RF XMTR. LOW BATTERY REPORT CODE
This is sent in the event that a wireless transmitter low battery
condition exists.
Press 68 CANCEL REPORT CODE
This is sent upon disarming of the system after an alarm condition
was reported.
Press 70 ALARM RESTORE REPORT CODE, 1st DIGIT
This is sent when the zone that caused an alarm is restored to its
non-faulted condition. 2nd digit is automatically sent as the 2nd
digit of the zone alarm report code programmed in field
expanded or 4+2 reporting is selected.
Press 71 TROUBLE RESTORE REPORT CODE
This is sent when a trouble in a zone is restored.
Press 72 BYPASS RESTORE REPORT CODE
This is sent when a zone that has been bypassed is un-
bypassed.
Press 73 AC RESTORE REPORT CODE
This is sent when AC power has been restored after an AC power
outage.
Press 74 LOW BAT RESTORE REPORT CODE
This is sent when a system low battery condition is restored to
normal.
Press 75 RF XMTR. LOW BATTERY RESTORE CODE
This is sent when a transmitter that previously sent in a low
battery message has sent a message indicating it no longer has a
low battery condition.
Press 92 NUMBER OF REPORTS IN ARMED PERIOD
This option can be used to limit the number of messages (alarm &
alarm restore reports) sent to the central station in an armed
period. "0" limits reports to a total of 10; "1" allows an unlimited
number of reports.
– 75 –
56, if