First Alert FA142C Installation Instructions Manual page 63

Default Descriptor
[
ZN 0 1 ZO NE 0 1
Flashing Cursor (system is
ready for entry of word).
[
ZN 0 1
Flashing Cursor
[
ZN 0 1 B A CK
ZN 0 1 B A CK
+
Flashing Cursor if "6" is
pressed (system is
ready for next word).
ZN 0 1 B A CK
D O O R
+
Flashing Cursor
– 63 –
4. Press "0" (No).*
If a descriptor was not entered
previously for zone 1, the default
descriptor for zone 1 will be displayed.
*
The procedure for adding custom words
to the built-in vocabulary will be found
later under "Adding Custom Words".
Note that no entries can be made. Entries
can be made only when the display
contains a flashing cursor, which signifies
the "entry mode".
5. To delete or change the default
descriptor for zone 1, press [ ] plus
the same zone number (01). This will
clear that descriptor and gain access to
the entry mode with flashing cursor,
allowing changes to be made.
Note:
If you do not wish to change the
existing descriptor for zone 1, enter [ ]
plus the next zone number for which
you wish to enter (or check) a
descriptor. A summary display for that
zone will appear. You must then press
[ ] plus the same zone number again
to gain access to the entry mode
(flashing cursor) for that zone.
6. Press # plus the 3-digit number for
the first word, using the " ALPHA
VOCABULARY LIST" on a following
page to locate the desired word and its
3-digit number.
Example: The descriptor that we wish
to enter for zone 1 is BACK DOOR.
From the list, BACK = 013. Therefore,
you would enter # 0 1 3 .
Note: If you accidentally enter the
wrong word, simply press [#] plus the
correct 3-digit number for the word you
want.
7. Press "6" to accept the selected
word and continue.
Note: If this is the only word you are
using for the descriptor, press "8"
instead of " 6" to save that word in
memory, and then go to step 11.
8. Enter the 3-digit number for the next
word. In our example, the word is
DOOR, whose number is "057".
Enter # 0 5 7. The display on the left
will appear.