Clearing Memory For Remotes - Genie SC 1500, TriloG 1200 Operation & Maintenance Manual

4
Optional Programming

CLEARING MEMORY FOR REMOTES

1
Press the Program Set button on the Powerhead
and hold 2 seconds, round LED comes ON.
PROGRAM
–
SET
HOLD HOLD
2 seconds 2 seconds
2
Release the Program Set button, round LED goes
off and the long LED flashes purple.
PROGRAM
SET
3
Press up arrow button (+) and down arrow
button (-) simultaneously on the Powerhead and
hold until both LEDs flash blue and then go OFF.
PROGRAM
–
SET
HOLD
PROGRAM
+
SET
– +
PROGRAM
+
SET
HOLD
4
To verify that the memory is cleared, press
a remote button that was previously
programmed to the Powerhead.
If the memory has been cleared, the Remote will not activate the door
opener.
NOTE: The garage door opener will operate normally using the Wall
Console.
NOTE: When the remote is pressed the round LED will flash blue but
will not activate the door opener.
NOTE: Clearing Remotes from the Powerhead memory will clear ALL
programmed Remotes and wireless Keypads. Your opener will no
longer recognize any signal received from a missing Remote.
All remaining (or recovered) Remotes and wireless Keypads MUST BE
reprogrammed as shown on pages 9 and 12.
(continued next page)
13