Removing And Replacing The Transceiver Board Assembly - Motorola V6 Service Manual

Digital wireless telephone

Hide thumbs Also See for V6:

Table of Contents

Level 1 and 2 Service Manual

Removing and Replacing the Transceiver Board Assembly

This product contains static-sensitive devices. Use anti-static handling procedures

to prevent electrostatic discharge (ESD) and component damage.

Remove the battery cover, battery, SIM, and rear housing as described in the procedures

The flexible printed cable (FPC) (flex) is easily damaged. Exercise extreme care when

handling.

Carefully work the flat end of the disassembly tool under the flex connector and remove

the connector from the transceiver board.

Lift the transceiver board assembly from the front housing. See Figure 7.

Figure 7. Removing the Rear Housing Assembly

To replace, insert the acoustic module on to the transceiver board assembly.

Then the flex connector should be mated with the PCB still held in hand.

The PCB should then be rotated into position into the front housing.

Replace the rear housing, SIM, battery, and battery cover as described in the procedures.

➧

Be sure the volume/smart buttons and voice button are correctly positioned in

relation to the corresponding switches on the transceiver board. Verify operation of

the buttons after replacing the transceiver board and rear chassis assembly.

October 26, 2006

Disassembly

040710o

Table of Contents