Motorola V6 Service Manual page 24

Disassembly
20
7. Lift the flip cover away from the flip assembly. Be careful not to damage the display flex
cable (see Figure 10).
Figure 10. Removing the Flip Assembly Cover
8. Use the plastic tweezers to unseat the flex connector from it's socket.
9. To replace, insert the smart buttons into the phone. Ensure the buttons contact their
respective switches on the display assembly.
10. Align the flip cover to the flip assembly, gently press the flip cover onto the flip assembly
until the flip cover latches engage.
11. Insert the 6 screws and tighten to a final torque setting of 1.5 inch pounds. Do not over
tighten. Avoid damage to the flex cable.
12. Use the main lens press to assembly the main lens. Press lens at 16.0 kgf and hold for 20
seconds.
13. Replace the transceiver board assembly, rear housing, antenna assembly, SIM, battery, and
battery cover as described in the procedures.
October 26, 2006
6809505A64-O
040723o