Important Safety - Marquis ULTIMATE HOT TUB EXPERIENCE! Owner's Manual

The following instructions contain important safety information. We strong-
ly encourage you to read and apply them.

IMPORTANT sAFETY

INsTRUCTIONs
WHEN INsTALLING AND UsING THIs ELECTRICAL EQUIP-
MENT, BAsIC sAFETY PRECAUTIONs sHOULD ALWAYs BE
FOLLOWED, INCLUDING THE FOLLOWING:
READ AND FOLLOW ALL
1.
INsTRUCTIONs
2. WARNING: To reduce the risk of injury, do not permit children to use
this product unless closely supervised at all times.
3. DANGER: RIsK OF CHILD DROWNING. Extreme caution must be
exercised to prevent unauthorized access by children. To avoid acci-
dents, ensure that children cannot use the spa or hot tub unless they
are supervised at all times.
120 VOLT, CORD CONNECTED MODELs
4. DANGER: RIsK OF INJURY. Connect only to a grounded source.
5. Do not bury the power cord.
6. WARNING: To reduce the risk of electric shock, replace a damaged cord
immediately.
7. A ground terminal (pressure wire connector) is provided on the surface
of the control box inside the equipment compartment. This connector
should be bonded with a minimum No. 8 AWG (8.42mm
in Canada) solid copper wire between this unit and any metal ladders,
metal water pipes, metal enclosures of electrical equipment, conduit, or
metal equipment within five feet (1.52m) of the spa. If the spa is located
on a reinforced concrete pad, the reinforcing steel should also be bond-
ed to the ground terminal.
8. WARNING: Your spa may be equipped with a Ground Fault Circuit
Interrupter (GFCI) on the end of the power supply cord. Before each use
of the spa, with the plug connected to the power supply and the unit
operating, press the "test" button. The unit should stop operating and the
GFCI power indicator will go out. Wait thirty seconds and then reset the
GFCI by pressing the "Reset" button. The GFCI power indicator will turn
on, restoring power to the spa. If the interrupter does not perform in this
manner, it is an indication of an electrical malfunction and the possibility
of an electric shock. Disconnect the plug from the receptacle until the
fault has been identified and corrected.
SAfE ty i NS tRUctiONS
) (No. 6 AWG
2
3