Marquis ULTIMATE HOT TUB EXPERIENCE! Owner's Manual page 63

SanItIZe
ConstantClean™ System (option)
The ConstantClean™ system utilizes a combination of sanitizers to increase
water quality and significantly decrease maintenance. The combination of
a Spa Frog® Mineral Cartridge* and the factory installed ozonator greatly
reduce the amount of sanitizer required. Instead of the normal 3 - 5 ppm of
bromine, you may only need to maintain 1 - 2 ppm of bromine.
note: The use of Spa Frog® floating cartridges is recommended. Do not
use other floating chemical dispensers or Biguanide. Damage to the spa
shell and other internal components can occur.
* The built-in sanitation system is not available in some international markets.
However, the ozone system is available on all spa models in all countries.
please see your dealer for recommended alternate treatment method if the
built-in sanitation system is not available.
BuIlt-In SanItatIon SyStem*
After shocking the spa water with Chlorine Sanitizer granules or non-chlo-
rine Spa Shock, bring the spa water to operating temperature. Then install
the Spa Frog® cartridges.
adJuSt the mIneral CartrIdGe
Remove the protective cellophane wrap from the Spa Frog® mineral car-
tridge. While holding the bottom of the cartridge, turn the top until the num-
ber six appears in the setting window.
NOTE: The mineral cartridge should be replaced every three to four
months. You will still feel the "spent" minerals inside, but they are no longer
effective and the cartridge needs to be replaced. It is recommended to
drain and refill the spa at the same time you replace the mineral cartridge.
adJuSt the BromIne CartrIdGe
Remove the protective cellophane wrap from the Spa Frog
tridge. Finding the right setting for the bromine cartridge will require moni-
toring your usage for the first few weeks. Begin with an initial setting based
on the chart below and monitor bromine levels daily for the first week or
so, adjusting the cartridge by one setting per day until a 3 - 5 ppm level has
been achieved. To adjust cartridge, remove from system and turn to the
next highest setting if the bromine level is low or the next lower setting if the
bromine level is high. The bromine cartridge needs to be replaced when
empty between two and four weeks. Always maintain 3 - 5 ppm of bromine.
Suggested Initial Bromine Cartridge Settings
daily filter time
one hour
two hours
four hours
spa care & e njoy ment guide
Spa Gallons
250-300 300-400
2 3
2 2
1 2
bromine car-
®
400-500
4
3
2
63