Marquis ULTIMATE HOT TUB EXPERIENCE! Owner's Manual page 52

Table of Contents

Advertisement

PlEaSE NotE: The following corrective actions may be performed by the
spa owner. If the trouble cannot be corrected in the steps below, please
contact your authorized Marquis
an unauthorized service provider or spa owner could result in damage not
covered by the warranty and could cause serious injury.)
EQUIPMENt WIll Not oPERatE
• Check the control panel LCD window for diagnostic code.
• 240V Spas: Check the circuit breaker on the main circuit panel.
• 120V Spas: Check the GFCI power cord and reset if necessary (see IM-
PoRtaNt SaFEty INStRUCtIoNS at beginning of manual).
• Check the condition of the power cord.
INaDEQUatE JEt aCtIoN
• Be sure the shut-off valves are completely open.
• Open the jets by turning the jet face to allow for maximum water flow.
• Check that the air control valve is open (rotate lever counterclockwise).
• Check for obstruction or restrictions at suction guard(s) or filters, such as
leaves, etc.
JEt valvES aRE HaRD to oPERatE
• Valves and rotating jets that become hard to turn is an indication of sand,
dirt or too high calcium level in the water.
• Remove components and rinse before damage occurs.
• Advise bathers to shower or use a foot bath before entering the spa. Fail-
ure to use or maintain valves as directed may cause damage by introduc-
tion of foreign materials such as dirt, sand and calcium that is not covered
under the warranty.
No HEat
• Check temperature displayed in the LCD window for desired temperature
setting.
• Inspect the filter cartridge(s) for dirt and debris.
• Check that the water is at proper level, 2/3 up the Vortex skimmer
opening(s).
• Check HEAT MODE to be certain spa is not in SLEEP MODE.
• Lower ambient temperatures may result in heat loss.
NotE: Do not expect instant hot water from the jets. It will take the heater
12- 24 hours to heat the water to the temperature you desire.
lIGHt DoES Not WoRk
• Press the LIGHT pad on the control panel.
• Reposition the light bulb in the socket. (See REPLACING LIGHT BULB.)
• Replace the light bulb with a 6 WATT BULB (GE 918 ONLY).
marquis t rouble sH oot ing guide
dealer for service. (Improper servicing by
®
52

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents