Important Safety Instructions Page(S); 120V, Cord & Plug Connected Models - Marquis Spas Owner's Manual

The following instructions are required to be printed by Underwriters Laboratories
(UL) as a condition of the listing of this product. They contain important safety
information, and we strongly encourage you to read and apply them.
IMPORTANT SAFETY
INSTRUCTIONS
WHEN INSTALLING AND USING THIS ELECTRICAL EQUIPMENT,
BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED,
INCLUDING THE FOLLOWING:
READ AND FOLLOW ALL
1.
INSTRUCTIONS
2. WARNING: To reduce the risk of injury, do not permit children to use this
product unless closely supervised at all times.
3. DANGER: RISK OF CHILD DROWNING. Extreme caution must be
exercised to prevent unauthorized access by children. To avoid accidents,
ensure that children cannot use the spa or hot tub unless they are supervised
at all times.
120 VOLT, CORD AND PLUG CONNECTED MODELS
4. DANGER: RISK OF INJURY. Connect only to a grounded source.
5. Do not bury the power cord.
6. WARNING: To reduce the risk of electric shock, replace a damaged cord
immediately.
7. A ground terminal (pressure wire connector) is provided on the surface of
the control box inside the equipment compartment. This connector should
be bonded with a minimum No. 8 AWG (8.4mm
between this unit and any metal ladders, metal water pipes, metal enclosures
of electrical equipment, conduit or metal equipment within five feet (1.5m) of
the spa. If the spa is located on a reinforced concrete pad, the reinforced
steel should also be bonded to the ground terminal.
8. WARNING: Your spa is equipped with a ground fault circuit interrupter
(GFCI) on the end of the power supply cord. Before each use of the spa,
with the plug connected to the power supply and the unit operating, press
the "test" button. The unit should stop operating and the GFCI power
indicator will go out. Wait thirty seconds and then reset the GFCI by pressing
the "Reset" button. The GFCI power indicator will turn on, restoring power
to the spa. If the interrupter does not perform in this manner, it is an
indication of an electrical malfunction and the possibility of an electric shock.
Disconnect the plug from the receptacle until the fault has been identified
and corrected.
NOTE: Failure to wait thirty seconds before resetting the GFCI may cause
the spas' power indicator on the control panel to blink. If this occurs, repeat the
GFCI test procedure.
page 4
SAFETY
INSTRUCTIONS
2
) solid copper wire