Important Safety Instructions; 240V, Permanently Installed Models; All Spa Models - Marquis Crown Summit Owner's Manual

SAFETY INSTRUCTIONS
The following instructions contain important safety information. We strongly encourage you to
read and apply them.

IMPORTANT SAFETY INSTRUCTIONS

WHEN INSTALLING AND USING THIS ELECTRICAL EQUIPMENT, BASIC SAFETY PRE-
CAUTIONS SHOULD ALWAYS BE FOLLOWED, INCLUDING THE FOLLOWING:
READ AND FOLLOW ALL
1.
INSTRUCTIONS
2. WARNING: To reduce the risk of injury, do not permit children to use this product unless
closely supervised at all times.
3. DANGER: RISK OF CHILD DROWNING. Extreme caution must be exercised to prevent unau-
thorized access by children. To avoid accidents, ensure that children cannot use the spa or
hot tub unless they are supervised at all times.
240 VOLT, PERMANENTLY INSTALLED MODELS
4. A ground terminal is provided on the control box. To reduce the risk of electric shock, connect
this terminal to the grounding terminal of your electrical service or supply panel with a
continuous green, insulated copper wire. The wire must be equivalent in size to the circuit
conductors supplying the equipment. In addition, a bonding terminal (pressure wire connec-
tor) is provided on the outside of the control box for bonding to local ground points. To reduce
the risk of electric shock, this connector should be bonded with a No. 8 AWG (8.42mm
6 AWG in Canada) solid copper wire to any metal ladders, water pipes, or other metal within
five feet (1.52m) of the spa to comply with local requirements.
5. Your spa uses ground fault circuit interrupters in the electrical sub-panel. Before each use of
the spa and with the unit operating press the Test button on each breaker. The switch should
click over to the "Trip" position. Wait thirty seconds and reset each GFCI breaker by switch-
ing it completely off and then completely on. The switch should then stay on. If either of the
interrupters does not perform in this manner, it is an indication of an electrical malfunction
and the possibility of an electric shock. Disconnect the power until the fault has been identified and
corrected.

ALL SPA MODELS

6. Install the spa so proper drainage is provided.
7. DANGER: RISK OF ELECTRIC SHOCK. Install the spa at least five feet (1.52m) away from
metal surfaces, in accordance with the National Electric Code ANS/NMFPA70-1993. Each
metal surface must be permanently connected to a minimum No. 8 (8.42mm
Canada) solid copper conductor attached to the wire bonding connector on the terminal box
provided for this purpose.
8. DANGER: RISK OF ELECTRIC SHOCK. Do not permit any appliance, such as a light, tele-
phone, radio, or television, etc. within five feet (1.52m) of the spa or hot tub.
) (No.
2
) (No. 6 AWG in
2
3