Subaru Legacy 2015 Owner's Manual page 407

7-42
Starting and operating/Parking your vehicle
prevent the vehicle from moving
and contact your SUBARU deal-
er.
. If the electronic parking brake is
operated when the brake is over-
heated or the vehicle is on a
steep slope, the brake system
warning light may flash. In this
case, the vehicle may start to
move and it may lead to an
accident. Always use the tire
stops.
CAUTION
. When the electronic parking
brake system has a malfunction
and the parking brake cannot be
applied, contact your SUBARU
dealer immediately for an inspec-
tion. If you have to park your
vehicle in such conditions, per-
form the following procedure.
Stop your vehicle in a flat
location.
Shift the shift lever in the 1
or reverse position (MT mod-
els).
Shift the select lever in the P
position (CVT models). When
the select lever cannot be
shifted into the P position,
you must release shift lock.
Refer to Shift lock function
7-26.
Use tire stops under the tires
to prevent the vehicle from
moving.
. Never drive while the parking
brake is applied because this will
cause unnecessary wear on the
brake linings. Before starting to
drive, always make sure that the
parking brake has been released
and the brake system warning
light has turned off.
Your vehicle is equipped with an electronic
parking brake. You can apply/release the
parking brake by operating the parking
brake switch.
To apply: Depress the brake pedal and
pull up the parking brake switch.
To release: Press the parking brake
switch firmly while the ignition switch is
in the ON position and the brake pedal is
depressed.
When the parking brake is applied while
the ignition switch is in the ON position,
the brake system warning light and the
indicator light on the parking brake switch
illuminate. Refer to Brake system warning
light 3-19.
NOTE
. If the parking brake switch is
pressed with the ignition switch in the
ACC or LOCK / OFF position, the
parking brake is not released.
. If the parking brake switch is
pressed without depressing the brake
pedal (all models) and/or clutch pedal
(MT models), the parking brake is not
released.
. The electronic parking brake system
uses motors to apply the parking
brake. Therefore, operating sounds
from the motors will be heard when
applying or releasing the parking
brake. Make sure that the motor
sounds are heard when applying or
releasing the parking brake.
. When the electronic parking brake
system has a malfunction or the elec-
tronic parking brake operation is pro-
hibited temporarily, if the parking brake
switch is operated, a chirp sound is
heard and the brake system warning
light flashes.
. When you cannot release the park-
ing brake due to, for example, a system
malfunction, contact your SUBARU
dealer and have your SUBARU dealer
release the parking brake.
. If the operation of the electronic