Subaru Legacy 2015 Owner's Manual page 207

3-58
Instruments and controls/Mirrors
1. Locate the training button on the
garage door opener motor head unit.
The exact location and color of the button
may vary by brand of garage door opener.
If it is difficult to locate the training button,
refer to your garage door opener s instruc-
tion manual.
1) Training button
2. Press the training button on the
garage door opener motor head unit
(which activates the training light on the
unit). Proceed to step 3 within 30 seconds.
3. Inside the vehicle, firmly press, hold for
2 seconds and release the HomeLink
button that was programmed in the pre-
vious section. Press and release the
button a second time to complete the
programming procedure.
NOTE
Some garage door openers may re-
quire you to do the above press-hold-
release sequence a third time to com-
plete the programming.
4. The garage door opener should now
recognize the HomeLink
System and your garage door opener
should activate when the HomeLink
button is pressed.
Programming for entrance gates
and garage door openers in
Canada
1. Unplug the motor of the entrance gate
or garage door opener from the outlet.
NOTE
If any of the HomeLink
already programmed for other devices,
skip step 2 because it clears the
memory of all three buttons.
®
1) HomeLink button 1
®
2) HomeLink button 2
®
3) HomeLink button 3
®
Wireless Control
®
®
buttons are
®