Connecting The Line Cord - Eizo SCD 19102 Instruction Manual

Connecting

6.7 Connecting the line cord

6.7 Connecting the line cord
The power supply socket is on the rear of the flat panel display (only open using appropriate
tool!). The display power supply is connected using an appliance plug.
● Insert the appliance plug of the supplied power cord into the mains socket.
● The power cord can be secured using a cable grip.
See also
Connector panel (Page 25)
Safety notes (Page 11)
28
WARNING
• Only use the supplied power cord, or a cable with PE conductor and appliance plug
to DIN 49 547, IEC 320 (max. length 3 m). Furthermore, the cable must adhere to all
local safety regulations applicable to the specific country in which the display is used.
• Device fuses must only be replaced by the repair centers or servicing department.
• Note for North America: Molded power supply plugs must comply with the
requirements for hospitals with respect to CSA Std. C22.2 No. 21 and UL 498.
SCD 19102 / SMD 19102
Instruction Manual, 05/2008, A5E01588521A-002